 |
Overview
The Suburban RV Aluminum Anode Rod is a replacement anode rod for Suburban RV Water Heaters that will preserve the life of the water heater by corroding themselves, so the water heater doesn't get corroded.
Features
- Aluminum anode rod.
- For use in Suburban RV water heaters.
- Absorbs the corrosive action caused by hot water.
- Extends water heater tank life.
- Anode rods should be replaced regularly.
- Limited 90-Day Manufacturer Warranty.
Note: Check your anode rod every time you empty you RV water heater as you may need to change, if corroded. To drain the tank, just unscrew the anode rode. Water with high levels of iron and/or sulfate will increase the rate of deterioration. Always carry a spare with you, as you never know when you will need to replace the part.
Specifications
- Length: 9".
- 3/4" thread size.
- Weighs: 1 lbs.
Instructions
- No Instructions Available.
Suburban RV Water Heater Aluminum Anode Rod, 9"
Anode Removal:- Turn off the power to the water pump.
- Turn off the gas supply and the electrical power to the water heater.
- Be sure the water is cool before attempting to remove the anode rod. To remove, rotate counter clockwise using a 1 1/16" socket wrench. It may take a lot of force to loosen, especially if it hasn't been removed in awhile. Stand clear when removing the rod, as water may splash.
- Drain water heater and flush sediments from the bottom of the tank.
New Anode Installation:- Wrap threads clockwise with Teflon thread sealant tape or sealing compound that is approved for potable water.
- Insert new anode rod in drain opening and rotate clockwise to tighten.
- Turn on water supply to refill tank with water. Check around threads at the anode rod for leaks. If there is a leak tighten anode.
- Turn on gas supply and electrical power.
|
|
|
