Home > Electronics >

Garnet 709-P3W SeeLevel II 3 Tank Monitor - Monitor Only

Garnet 709-P3W SeeLevel II Monitor - Monitor Only

Alternative Views:

Price: $89.95

MFG P/N: 709-P3W-MO
MFG: Garnet Instruments
SHIPS: Same Business Day Before 1 PM EST

Quantity in Stock :4

Availability: In Stock

Qty:

Description

Instructions

The Garnet 709-P3W is a tank monitor that works with the 709-P3W SeeLevel II Tank Monitoring System. It is designed for accurate level measurement of motorhomes and trailers with three holding tanks. This system monitors battery voltage, fresh, grey, and black water levels as well as the LPG tank. The level in percent is shown on a three digit LED display. This model includes a 3-way pump switch with connector which allows for more wiring options. Note: This is the monitor only.

Works with 709-P3W SeeLevel II Tank Monitoring System
Purchase as a second console to be installed outside by the holding tanks
Provides accurate tank level information using percentage of full readout
Uses common industry connector for ease of installation and servicing
Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
Current drain is less than 200mA
Panel Dimensions: 4" W x 2.8" H x 1" D
- Required Cutout Size: 3" W x 1.8" H
Includes: (1) SeeLevel 709-P3W monitor and connector assembly/pigtail
Limited 1 year manufacturer warranty

Garnet 709-P3W SeeLevel II Monitor - Monitor Only

Additional Product Information
Display mounting panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.

System power requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.

Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.

LPG: Display will work with an LPG sender with a maximum resistance of 50 ohms to 500 ohms. Display shows increasing level as resistance increases. System must be calibrated with the LPG tank full, or it can be factory calibrated.

Pump Switch: The pump switch is rated for a maximum of 10 amps. The use of a relay is required if more than 10 amps is needed. We recommend using a 10 amp fuse inline with the switch.