Home > Electronics > Seelevel Tank Monitoring System >

SeeLevel II 4 Tank Monitor - Monitor Only
Garnet 709-4PH SeeLevel II Tank Monitor - Monitor Only
Garnet 709-4PH SeeLevel II Tank Monitor - Monitor Only
 
Price: $93.63
MFG P/N: 709-4PH-MO
MFG: Garnet Technologies
SHIPS: Eastlake, Oh

Quantity in Stock :

Availability: Out of Stock
No Longer Available

Description
 
The Garnet 709-4PH is a tank monitor that works with the 709 SeeLevel II Tank Monitoring System. Itis designed for accurate level measurement of 5th wheel trailers with four holding tanks. This system monitors battery voltage, fresh, grey, galley and black water levels. The level in percent is shown on a three digit LED display. This model includes a single-pole pump switch, a single-pole heater switch and a heater pilot out light on the display panel. Note: This is the monitor only.
  • Works with 709-4PH SeeLevel II Tank Monitoring System
  • Purchase as a second console to be installed outside by the holding tanks
  • Provides accurate tank level information using percentage of full readout
  • Uses common industry connector for ease of installation and servicing
  • Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
  • Current drain is less than 200mA
  • Panel Dimensions: 4" W x 2.8" H x 1" D
    • Required Cutout Size: 3" W x 1.8" H
  • Includes: (1) SeeLevel 709-4PH monitor and connector assembly
  • Limited 1 year manufacturer warranty

Garnet 709-4PH SeeLevel II Tank Monitor - Monitor Only

Additional Product Information
Display mounting panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.

System Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.

Wiring:
A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.

Pump and Heater Switches:
The pump and heater switch is rated for a maximum of 6 amps. A relay is required if more than 6 amps is needed. A 7.5 amp fuse is included.

ACCESSORIES
Garnet 709-filler SeeLevel 709 Filler Plate Garnet 709-gasket SeeLevel 709 Gasket
Price: $10.25
Price: $10.25
Garnet 709-filler SeeLevel 709 Filler Plate Garnet 709-gasket SeeLevel 709 Gasket