Home > Electronics > Seelevel Tank Monitoring System >

Garnet 709-4P SeeLevel II 4 Monitor - Monitor Only

Garnet 709-4P SeeLevel II Monitor - Monitor Only

Price: $84.95

MFG P/N: 709-4P-MO
MFG: Garnet Instruments
SHIPS: Same Business Day Before 1 PM EST

Quantity in Stock :5

Availability: In Stock

Qty:

Description

Instructions

The Garnet 709-4P is a tank monitor that works with the 709-4P SeeLevel II Tank Monitoring System. It is designed for accurate level measurement of 5th wheel trailers with four holding tanks. This system monitors battery voltage, fresh, grey, galley and black water levels. The level in percent is shown on a three digit LED display. This model includes a single-pole pump switch on the display panel. Note: This is the monitor only.

Works with 709-4P SeeLevel II Tank Monitoring System
Purchase as a second console to be installed outside by the holding tanks
Provides accurate tank level information using percentage of full readout
Uses common industry connector for ease of installation and servicing
Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
Current drain is less than 200mA
Panel Dimensions: 4" W x 2.8" H x 1" D
- Required Cutout Size: 3" W x 1.8" H
Includes: (1) SeeLevel 709-4P monitor and connector assembly/pigtail
Limited 1 year manufacturer warranty

Garnet 709-4P SeeLevel II Monitor - Monitor Only

Additional Product Information
Display Mounting Panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.

System Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.

Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.

Pump Switch: The pump and heater switch is rated for a maximum of 6 amps. A relay is required if more than 6 amps is needed. A 7.5 amp fuse is included.