 |
 |
 |
|
The Model 714 SeeLevel II Tank Monitoring System features the most comprehensive display Garnet Technologies offers! View the level of each holding tank, two temperature sensors and LPG or battery voltage in real time. Includes (1) monitor, (3) 710ES tank sensors, (1) temperature sensors, monitor mounting screws, monitor connector with wire leads and instruction manual.
- Provides accurate tank level information in percentage of full
- Fresh, grey and black water tanks are monitored using Garnets proprietary external level sensing technology.
- This ends fouling problems caused by debris build-up in the holding tank
- Measures tanks up to 14 inches tall with a single sender or 26 inches tall with dual senders
- Detailed diagnostic information monitors sender operation
- Temperature sensor(s) can be mounted inside or outside
- Panel measure approximately 2 3/4" wide by 5 3/4" high by 1" thick
- Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts.
- Current drain is less than 200mA.
- Temperature accuracy +/-3F (+/-1.5C).
- Note: The 12" 710-ES can be exchanged by the 6″ 710JS or 16" 710SS Senders. (If you need to exchange senders, please call 866-332-7881 to place your order. Additional charges may apply.)
- Limited 1 year manufacturer warranty.
SeeLevel II Tank Monitoring System Model 714 represents a massive leap
*Note: This system will not work on metal tanks
SeeLevel II Model 714 Tank Monitoring System
- Resolution: 3/8 inch (10mm)
- Accuracy: +/- 8% or better, limited by resolution and tank shape
- Operating temperature range: +32 to +140°F (0 to + 60°C)
- Sender materials: 0.008” thick glass epoxy circuit board with conformal coating for circuit protection. Laminated on the back with 3M300LSE BondingAdhesive.
- Sender length range: 4-1/2 to 12 inches, which willmeasure tank heights from5” to 14” (single sender) and up to 26” (dual senders).
- Display mounting panel: Black panel, approximately 2¾” wide by 5¾” high by 1” thick Panel screws to wall.
- System power requirements: Display requires 12 volts from the RV battery; the system will function from 11 volts to 16 volts. Current drain is less than 200mA.
- Wiring: Asingle two wire conductor required fromthe display to the senders. All the senders are wired in parallel. Single wire required for existing LPGsender if
- sender grounded at tank.
- Temperature sensor: Semiconductor sensor with integralA/D converter. Accuracy +/- 3 degrees
- Fahrenheit (+/- 1.5 degrees Celsius).
|
|
|
 |
|
 |
|
