Home > RV Parts & Hardware > Gutter Spouts & Systems >

RK Black Streak Relief
RainKap RK Black Streak Relief
 
Alternative Views:


Price: $93.49
MFG P/N: RK
MFG: Rainkap
SHIPS: 7

Quantity in Stock :

Availability: Out of Stock
No Longer Available

Description
 
RainKap will prevent black streaks on your RV siding. GUARANTEED! Rainkap is made of a UV stabilized PVC, comes in one continuous length and easily installed. Prevents streaks and stains and provides leak protection on Travel Trailers, Fifth Wheels, RV's etc. It reduces the use of streak cleaners which can damage your RV Camper finish. Available in several lengths. RainKap (RainCap) is NOT used at the awning unless its mounting is below the roofline molding like some Fifth Wheels. Easy to roll in with the concave wheel of a screen spline tool and cut to length

RainKap Black Streak Relief

Additional Product Information
Routes dirty rooftop water away from the siding, window mounts, storage compartment doors and slide seals preventing saturation, leaks and black streaks.

Seals the roof edge molding screws for additional leak protection at the roofline.Easily replaces common one inch trim insert on many styles of roofline molding. (NOT PRESENT ON ALL RV MOLDINGS)

Protects and saves your investment, time and money. Relax and enjoy less upkeep with Black Streak Relief the RV Travel Trailer Accessory Part by RainKap Ltd.

RV RainKap (RainCap) comes with a 90-DAY MONEY BACK GUARANTEE. It is supplied as one continuous length coil and cut to fit at your RV, Trailer, Fifth Wheel, Horse Trailer, Utility Trailer, Camper etc. The lengths are: 28, 36, 40 and 48 feet. RainKap's patented trim insert replacement helps preserve and protect your unit and your time. The RainKap (RainCap) provides ease of upkeep and preserves your unit by extending dirty rooftop water away from the siding etc. Guaranteed Relief...

Installation Instructions
___________________
/i//RainKap_Remove_Insert_Drawing.jpg

Note: An Anvil Pruner works great for cutting or trimming. Gradual angles on moldings are alright. Sharp turns require a v-notch or cut on the bottom leg. To ease installation have RainKap WARM AND PLIABLE and use a screen tool. A hair dryer on high setting will WARM the RainKap. Remove the one-inch vinyl insert. Standard molding shown. Insert a section of the bottom leg into the lower channel (shown below) with the RainKap sloped downward.

Roll the concave wheel of a screen spline tool (shown below) along the top leg using a downward and inward force to insert the top leg. Repeat until the complete length is installed. Cut off the excess. (Recommended) Silicone caulk the bottom leg at each end and the opening at the screw clearance arch. Caulk the upper caulking channel its entire length. (The caulking channel provides an extra measure of leak protection.)/i//RainKap_Install_Drawing.jpg


/i//Tool200.gif