 |
 |
 |
|
The RV Automations Shore Power Command is an auto generator start system that monitors your shore power and auto-starts your generator in the event of a power outage.- Monitors shore power directly from a 50/30-amp pedestal. No modifying required to your inverter panel or transfer switch.
- May be DIY installed, or installed by a dealer. No complex wiring is involved. Includes heavy-duty connectors and posi-taps for easy wire splicing.
- Tested on most Onan RV generators.
- Works with generators that have the following 4 wires: start wire, stop wire, run wire, and ground wire.
- Shore power is monitored on the 120V side of your transfer switch, allowing Shore Power Command to monitor shore power right from the source (power pedestal).
- Ready to install right out of the box. No hard-to-read programming is required for setup.
- May be installed inside your RV, generator compartment, or near your transfer switch.
- Runs parallel with any factory-installed auto generator start system.
- Rugged compact, durable design.
- What is required for installation: (4) 18-gauge wires for generator connection, (1) pair of 14-gauge wires to connect to battery and ground, (1) pair of 14-gauge wire to connect from the transfer switch to Shore Power Command, (4) screws to mount Shore Power Command.
- Tools needed to install: Wire stripper, screwdriver (Philips or Flathead) small zip ties, or electoral tape.
- Enclosure Dimensions: 7-1/2” wide x 4-3/4” width x 1-1/2” height.
- Weight: 3 lbs.
- Includes (1) Shore Power Command unit, (2) heavy-duty screw connectors, (1) 120V inline fuse, (4) posi-taps.
- Limited 3-Year Manufacturer Warranty.
RV Automations Shore Power Command Auto Generator Start & Monitoring System
|
|
|
 |
|
 |
|
