 |
The Micro-Air ASY-364-X20-IP EasyStart (without installation kit) is a one-of-a-kind custom-developed soft start device allowing you to run up to 2 RV air conditioners on a single 30 amp cord.
- Designed for 9K, 13.5K & 15K RV Rooftop Air Conditioners
- Employs a 4-part start ramp sequence that is self-optimizing, resulting in the lowest possible start-up current.
- Compatible with pure or modified sine inverters.
- Audibly quieter and smoother compressor startups.
- Enhanced fault detection protects the compressor.
- Integrated short-cycle prevention.
- Delivers 65-75% start current reduction as compared to a compressor's LRA (locked-rotor amperage).
- Specialized fault checks provide further protection for your compressor.
- Capable of supporting up to a 18,000 BTU (1 - 1.5 tons) compressor.
- Fully weatherproof casing (IP65), flameproof, a plastic enclosure with an integrated mounting flange, and a 40" wire harness.
- Supports 100-125VAC, 50-60Hz motors
- Mounts inside the rain shield on a rooftop unit.
- EasyStart 364 General Installation Manual
- Dometic Installation Manual
- Coleman Mach Installation Manual
- Note: Installation kit sold separately, see part KIT-364-368-RT2
- Dimensions: 7.64" L x 3.58" W x 2.50" H.
- Weight: 3 lbs
- Limited 2-Year Manufacturer Warranty.
Important Note: Each AC unit requires an EasyStart unit to be installed (only 4 wires to connect).
Will EasyStart run my 13.5K or 15K RV A/C on a Honda EU2000i?
Yes, but you most likely will not be able to run anything else in your RV. Also, the Honda EU2000i may not have enough power at or above 4000' altitude.
Can I install this on my RV or does it require a technician? EasyStart is a DIY device but does require you to climb onto your RV's roof to install it inside the rain shield of your AC. The wires are run to 4 points inside the electric box of your unit. There are wiring diagrams for most rooftop AC units down below.
|
|
|
