![](/v/vspfiles/templates/rvup2021/images/DBox_Border_Left_Top.gif) |
![](/v/vspfiles/templates/rvup2021/images/clear1x1.gif) |
![](/v/vspfiles/templates/rvup2021/images/DBox_Border_Right_Top.gif) |
![](/v/vspfiles/templates/rvup2021/images/clear1x1.gif) |
The Easi-Move V4 is a system of motors which engage onto the tires of a trailer so it can be moved by an electronic remote control. No more struggling, makes reversing or positioning your trailer onto a driveway or campground as easy as 1 2 3! The Easi-Move V4 also makes hitching a breeze, move the trailer to the truck instead of reversing and trying to line it up. The motor has aluminum rollers that are safe on tires. The Easi-Move V4 will move a trailer forwards, backwards, left or right, It will even rotate a single axle trailer 360 degrees! The motors are to be permanently mounted to the chassis of the trailer; the motors engage on and off the tires with a crank handle. Don't worry, The trailer will stop if out of range of remote or if any malfunction occurs. Can be used with travel trailers, boat trailers, horseboxes, cargo trailers, utility trailers, etc. Fits tandem axle trailers up to GVRW 7750lbs (Four motors). Comes with 4 Motors and all necessary installation hardware.Royal Easi-Move V4
Model
|
Royal Easi-Move V4
|
Operational Voltage
|
12 Volt DC
|
Average Current
Consumption
|
20 Ampere
|
Maximum Current
Consumption
|
100 Ampere
|
Speed
|
approx. 13cm per sec.
|
Weight
|
approx. 176lbs (exclusive of
battery)
|
Permissible Overall
Weight
|
7750 lbs
|
Permissible Overall
Weight on 15% Gradient
|
5500 lbs
|
Minimum Width
(trailer)
|
71"
|
Maximum Width
(trailer)
|
99"
|
Maximum Tyre Width
|
8"
|
Power Source (deep
cycle battery)
|
12V 105Ah (recommended), 12V 85Ah
(minimum) 2sets or 12V 200Ah (recommended), 12V 150Ah (minimum)
|
Universal brackets which clamp to an āIā beam type chassis are supplied. The bracket is 6ā wide and adjustable in height to suit different travel trailers. To fit a mover you will need a 16ā clearance from each tire and clear space to fit the bracket. Obstacles such as scissor jacks and pipes can be relocated. Once the mover has been attached to the chassis, two wires from each motor simply connect to the control unit. The Electronic Control Unit should be fitted in a dry area such as a storage compartment or under a seat or a bed. Then connect the Electronic Control Unit to the battery and your ready to move!
|
|
![](/v/vspfiles/templates/rvup2021/images/clear1x1.gif) |
![](/v/vspfiles/templates/rvup2021/images/DBox_Border_Left_Bottom.gif) |
![](/v/vspfiles/templates/rvup2021/images/clear1x1.gif) |
![](/v/vspfiles/templates/rvup2021/images/DBox_Border_Right_Bottom.gif) |
![](/v/vspfiles/templates/rvup2021/images/clear1x1.gif)
|