 |
Additional Product Information
Using Ez Battery Check Water Level Monitor
1. Ensure the battery is fully charged.
2. The battery's electrolyte level should be at the manufacturer's recommended level. Add distilled water if necessary. Do not over fill.
3. Remove the original vent cap and install the Ez Check Battery cap.
4. Note the level of the red float indicator and position the O ring even with the bottom of the red float indicator.
5. The Ez Check cap is now ready to be monitored. When the red float indicator drops below the O ring, remove the small black cap on the fill tube and slowly add distilled water to the cell until the red float indicator rises above the O ring.
6. Re-install the small black cap and you're done.
Batteries should be checked frequently to maintain the correct fluid levels.
|
|
|
