 |
The CoFair Products Quick Roof Extreme RV Repair Tape will stop leaks in just about any surface, including EPDM, TPO, metal, fiberglass, PVC, vinyl, wood, OBS, and much more. It makes a permanent bond using a steel-loc adhesive and will not crack, harden or shrink during severe weather conditions.- Material Thickness: 45 Mils Nom.
- Flexibility @ -20ºF: Pass
- Vapor Permeance: <.01
- Nail Sealability: Pass
- Tensile MD: 32 lbs/in
- Tensile CMD: 33 lbs/in
- Elongation MD: 33 lbs/in
- Elongation CMD: 779%
- Adhesion to Plywood @ 75ºF: 51 lbs/ft
- Adhesion to Plywood @ 40ºF: 14 lbs/ft
- 4" x 75 ft RV roof repair tape.
- Used on EPDM, TPO, metal, fiberglass, PVC, vinyl, wood, OBS, and much more.
- Permanently repairs RV roof, vents, skylights, slide-outs, windows, awnings, holding tanks, tents, and more.
- Made with Steel-Loc Adhesive.
- Can be applied to damp surfaces.
- Weight: 3 lbs.
- Limited 15-Year Manufacturer Warranty.
- Made in the USA.
CoFair Products Quick Roof Extreme RV Repair Tape - White 4" x 75'
DIRECTIONS FOR USE — Apply Quick Roof when air and substrate temperatures are a minimum of 45 F or warmer. With backing paper attached, unroll Quick Roof and position over the area to be repaired. Use a sharp utility knife or scissors to cut to the correct size. Remove release paper and press in place. To maximize adhesion, the use of a small hand roller is recommended. On larger repairs, slowly and carefully unroll Quick Roof peeling off the release paper and pressing in place as you go. Be sure to eliminate air pockets and keep the roll properly aligned. Quick Roof will adhere to itself. A minimum overlap of two inches is recommended on side seams, and six inches on end seams. If repairing a large sloped area, installation should begin at the low point and proceed up the slope of the roof.
|
|
|
