• Works with all sizes and brands of 12 volt flooded (filler cap) and sealed maintenance free batteries and 12V Lithium batteries.
• 7 stages of charging:
• 1) Analyze: Test-qualify/accept or reject battery.
• 2) Desulfate: begins removal by dissolving harmful sulfate.
• 3) Soft start: applies low current if battery tests low.
• 4) Bulk: provides maximum output to charge to 85%.
• 5) Absorption: provides low current to complete to 100%.
• 6) Test: to determine if battery needs further desulfation.
• 7) Maintenance: maintains temperature-compensated full-charge.
• Diagnoses battery’s condition, predicts failing batteries before they die.
• For all 12-Volt Sealed and Wet “Filler Caps” Batteries Including AGM, PLT and Odyssey.
• This BatteryMINDer is an Odyssey-approved charger.
• Will not overcharge, no matter the amperage selection.
• If your battery is charged and in good shape, use 2 amp setting.
• If charging a large deep cycle battery or more than 1 battery, use 4 amp setting.
• Wet/AGM/sealed setting will likely be used the most. Use the Odyssey selection on all named Odyssey batteries at 8 amp setting.
• Built-in temperature sensor automatically adjusts charge rate to ensure full-charge between temperature extremes.
• Simple push-button selector for all battery types and charging rates.
• 100% full time U.S. patented pulse-type desulfation keeps lead acid batteries free of sulfate.
• Detects and rejects bad cell batteries.
• Maximizes battery life and capacity.
• Diagnoses your battery’s condition and state-of-charge.
• Recovers weak or deeply discharged batteries: including flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
• Maintain up to 8 batteries at a time. (Requires BatteryMINDer® Y-Connector Accessory 210-AY, sold separately).
• Auto restarts after power outages.
• Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
• Automatically detects input AC power.
• ECO-mode with high-efficiency, low power consumption.
• 18 LED indicators show state-of-charge and important status mode/battery condition.
• Not designed for nickel–cadmium (NiCad), nickel–metal hydride (NiMH) or aircraft batteries.
• Includes (1) 128CEC2 charger-maintainer-desulfator, (1) 6' AC cord, (1) 6' DC cord with quick connector (SAE), (1) auto-temp compensation sensor (pre-installed), (1) insulated battery clip cord set with quick connector and 15A replaceable fuse, and (1) ring terminal cord set with quick connector and 15A replaceable fuse.
• Voltage: 12V.
• Charging Current: 2/4/8 amps.
• Power Source: 90-140 VAC, 47-63 Hz.
• Temperature Compensation: -4°F (-20°C) to 122°F (50°C)
• IP65 protection: Dust tight. No ingress of dust; complete protection against contact. Protection from water projected by a nozzle (6.3 mm) against enclosure from any direction shall have no harmful effects.
• Dimensions: 4.9" length x 7.3" width x 2.1" height.
• Weight: 3 lbs.
• Manufacturers warranty: 1 Year 100% Money Back Guarantee, 5 Year "No Hassle" Warranty.

BatteryMINDer 12V 2/4/8 Amp Charger-Maintainer-Desulfator & Lithium Charger Maintainer