|
INSTALLATION
INSTRUCTIONS
THETFORD
AQUA-MAGIC® V |
| 1.
Remove the stool. |
A. Remove two bolts, one on each
side.
B. Remove the water line located at the rear of the stool.
( MAKE SURE WATER IS OFF )
|
| 2. Locate
flush line between vacuum breaker and bowl. |
A. Flush line is located to left
rear of stool. [Photo View A]
|
 |
B. Remove Water Module Link and
discard. [It is the corrugated line.]
C. Use the two pieces of ½ inch id clear vinyl tubing provided in
kit, one 1½ inch long and one 2½ inch long.
|
D. With the clamps provided,
secure the two pieces with the arrow pointing towards the longest. [Photo
View B]
|
 |
E. Insert assembly through the
hole [Photo View C] and attach the nozzle assembly. (No
clamp needed)
|
 |
Slide the other end over nipple at
the Water Module and clamp. ( [Photo View D]
Snap nozzle assembly in place.
|
 |
| 3.
Reinstall stool, making sure all gaskets, bolts and water connections
are secure.
|
| 4. Mounting
the dispenser reservoir to the wall. |
A. Locate reservoir to the back
or side wall providing easy access for filling.
B. Keep reservoir lower than back of stool.
C. Screw reservoir into place with the three screws provided with
kit.
|
| 5. FINAL
CHECK LIST |
A. Check water line for leaks.
B. Check stool by flushing.
C. Add a few ounces of
Blue Streak
Chemical® to reservoir.
D. Flush stool. Finish filling reservoir.
|
| 6. Q: How Do
I Winterize the Blue Streak Dispenser? |
A:
Run the chemical level low [1to 2 inches] in the
reservoir and winterize your unit as you would normally. To remove
chemical from the reservoir; unscrew the tank from the wall leaving
tubing attached to tank and pour chemical into another container.
|
